Level 3
The figure is made up of two identical squares, ABCD and WXYZ. The area of each square is 100 cm2. Point A is the centre of Square WXYZ. Find the unshaded area.
Level 3
The figure is made up of two identical squares, ABCD and WXYZ. The area of each square is 100 cm2. Point A is the centre of Square WXYZ. Find the unshaded area.
Level 3 PSLE
Two rectangular tanks are shown. At first, Tank X was empty and one quarter of Tank Y was filled with water. Both taps were turned on at the same time and water from both taps flowed at the same rate of 1.6 litres per minute. How much time will it take for the height of the water to be the same in both tanks? (1 litre = 1000 cm3 )
Level 3 PSLE
Two rectangular tanks are shown. At first, Tank X was empty and one quarter of Tank Y was filled with water. Both taps were turned on at the same time and water from both taps flowed at the same rate of 1.6 litres per minute. How much time will it take for the height of the water to be the same in both tanks? (1 litre = 1000 cm3 )
Level 3
After cycling for 30 km, Mark took a break before he continued cycling 13 of the remaining distance. He then realised that he still had 14 of the total distance not completed. If Mark's average speed was 30 km/h, how much time did he take to complete the entire ride? Express the answer in mixed number.
Level 3
A car was on its way from Town X to Town Y. After covering 25 of its journey, it passed a van which was travelling at an average speed of 70 km/h. 5 hours later, the car reached its destination, but the van was still 28 km from Town Y. If the car had also started from Town X, how long would it take to travel from Town X to Town Y? Express the answer in mixed number.
Level 3 PSLE
At first, 18 of a tank was filled with water. A tap was turned on for 30 min for more water to flow into the tank. It was then turned off. The line graph shows the volume of water in the tank over the 30 min.
How many litres of water flowed into the tank in one minute?
At the end of 30 min, what fraction of the tank was filled with water?
The tap was turned on again to fill up the tank at the same rate as before. How many more minutes did it take for the tank to be filled completely?
Level 3 PSLE
At first, 18 of a tank was filled with water. A tap was turned on for 30 min for more water to flow into the tank. It was then turned off. The line graph shows the volume of water in the tank over the 30 min.
How many litres of water flowed into the tank in one minute?
At the end of 30 min, what fraction of the tank was filled with water?
The tap was turned on again to fill up the tank at the same rate as before. How many more minutes did it take for the tank to be filled completely?
Level 3
The figure is not drawn to scale. It shows a container made of two connected cubical tanks, A and B. Tank A is sealed at the top and completely filled to the brim. Tank B is 35 filled with 129600 mℓ of water. The height of the water level in Tank B is 1 cm higher than that in Tank A. The height of Tank B is 60 cm. Water is then drained from the container and the height of the water level from the base falls to 30 cm.
What is the capacity of Tank B?
What is the volume of water in the tank now in litres?
Level 3
The figure is not drawn to scale. It shows a container made of two connected cubical tanks, A and B. Tank A is sealed at the top and completely filled to the brim. Tank B is 35 filled with 129600 mℓ of water. The height of the water level in Tank B is 1 cm higher than that in Tank A. The height of Tank B is 60 cm. Water is then drained from the container and the height of the water level from the base falls to 30 cm.
What is the capacity of Tank B?
What is the volume of water in the tank now in litres?
Level 3
After 20 minutes into a race, Daniel has run 58 of the route while Piolo has covered only 38 of the distance. Daniel runs at the same average speed throughout the race and Piolo's average speed is 60 m/min slower than Daniel's. If Piolo wants to finish the race at the same time as Daniel, by how many percent should he increase his average speed by for the remaining part of the race? Round off the answer to the nearest whole number.
Level 3 PSLE The figure shows the amount of water in two rectangular Tanks, A and B, at first.
Ray poured 14 of the water from A into B to fill it to the top, without overflowing.
How much water was there in A at first?
Ray then poured all the water from B into A. 720 cm3 of water overflowed from A. What was the height of A?
Level 3 PSLE The figure shows the amount of water in two rectangular Tanks, A and B, at first.
Ray poured 14 of the water from A into B to fill it to the top, without overflowing.
How much water was there in A at first?
Ray then poured all the water from B into A. 720 cm3 of water overflowed from A. What was the height of A?
